- AC Servo System VCⅡ series
-
Slave 서보 드라이브
-
MECHATROLINK Spec
M-II M-III M-4
CKD니키덴소 주식회사Updated on：Oct 24, 2019
It corresponds not only to high function direct drive servomotor (DD motor), but it is also able to fit to linear servomotor and synchroneous and induction type AC servomotor to bring out the optimal perfomance of these motors from high response to ultra low speed range.
Funtions to optimaize the motor performance
- Auto notch filter to improve the efficency for the esonance control operation
- 4 kinds of Gain selction functions to choose the suitable gain to match with the load condition
- Effective resonance control filter function to control resonance at the distal end of machine.
- Smooth startup can be done by using the special data edting software with opration function, monitoring, editing, and analysis function
Specifications
| Item | Specifications | |
|---|---|---|
| MECHATROLINK Conmmunication | Behavioral specification | Position control by MECHATROLINK-Ⅲ communication |
| Command input | MECHATROLINK-Ⅲ command (Alarm/Warning readout, Interpolation feeding, Positioning, etc.) | |
| Output capacity (Input power source) |
50 to 200W (AC100V to 115V 50/60Hz Single phase) | |
| 0.1 to 37kW (AC200V to 230V 50/60Hz 3-phase) | ||
| 0.26 to 55kW (AC400 to 460V 50/60Hz 3-phase) | ||
| Number of control axes | Single axis | |
| Control input signal | Number of channels | 4 points (see “Note”) |
| Function | Emergency stop*, Zero point deceleration, Speed over ride, Positive/Negative over travel* | |
| Control output signal | Number of channels | 4 points Allocating to each signals (see “Note”) |
| Function | Servo ready, Alarm (*), Warning (*), Positioning complete, Speed zero, Torque limiting, Brake release, Soft limit switch, Marker output, Speed/Torque/Rough positioning/Pulse train mode running | |
| Auto tuning functions | Possible to tune for the case with relatively large inertia ratio by parameter setting | |
| Gain selection fuctions | • 4 kinds of gain selection are possible by High-level controller • Capable to correspond to the position loop gain for the Gain selection |
|
Note: The signal with * is Negative logic, and The signal with (*) is possible to for changing logic by the parameters.
MECHATROLINK specifications
| M-Ⅲ | |
|---|---|
| Profile | Standard servo |
| Data size | 32byte, 48byte |
| Transmission cycle | 0.5ms to 4.0ms |
Contact Information
CKD니키덴소 주식회사
| Sales Dept. | 216-0003 카나가와현 가와사키시 미야마에구 아리마 2-8-24 TEL: +81-44-855-4311 FAX: +81-44-856-4831 |